TY - JOUR
T1 - Characterization methods for strain-induced damage in polypropylene
AU - Wiener, Johannes
AU - Preissegger, Florian
AU - Plank, Bernhard
AU - Arbeiter, Florian
AU - Kolednik, Otmar
AU - Pinter, Gerald
N1 - Funding Information:
This research was supported by the Austrian Research Promotion Agency (FFG) as part of the project “Entwicklung und Optimierung von hoch risszähen, polymeren Mehrschicht‐Verbundsystemen nach biomimetischen Prinzipien,” grant agreement 858562, referred to with the acronym “BioMimicPolymers.” CT scans and evaluations were performed within the projects “BeyondInspection (grant number: 874540)” and “pore3D (grant number: 868735).” Both CT projects were funded by the State Government of Upper Austria and Austrian Research Promotion Agency (FFG).
Publisher Copyright:
© 2022 The Authors. Polymer Engineering & Science published by Wiley Periodicals LLC on behalf of Society of Plastics Engineers.
PY - 2022/4/4
Y1 - 2022/4/4
N2 - Various methods are used to characterize the deterioration of mechanical properties in polymers. The focus is set on distinguishing between time-dependent and irreversible damage in two different grades of polypropylene. First, digital image correlation is utilized to capture the stress–strain behavior during monotonic tensile tests. Changes in specimen volume are recorded throughout the experiment and serve as an indicator for crazes and voids. However, the elastic modulus, E, cannot be monitored throughout the entire experiment. Further analysis is performed in the form of cyclic load–unload tests. E and the residual strain, εres, as a function of the applied strain, εappl, are obtained for each cycle. Results show that E primarily suffers from the time-dependent behavior of the tested polymers in this case. Subsequently, an alternative technique is applied, where specimens are prestrained and then allowed to relax. In the following dynamic mechanical analysis, viscoelastic effects can be avoided. Considerations on the onset and evolution of damage are made. Ultimately, these results are confirmed through microcomputed tomography, where the shapes and densities of defects are captured in high resolution.
AB - Various methods are used to characterize the deterioration of mechanical properties in polymers. The focus is set on distinguishing between time-dependent and irreversible damage in two different grades of polypropylene. First, digital image correlation is utilized to capture the stress–strain behavior during monotonic tensile tests. Changes in specimen volume are recorded throughout the experiment and serve as an indicator for crazes and voids. However, the elastic modulus, E, cannot be monitored throughout the entire experiment. Further analysis is performed in the form of cyclic load–unload tests. E and the residual strain, εres, as a function of the applied strain, εappl, are obtained for each cycle. Results show that E primarily suffers from the time-dependent behavior of the tested polymers in this case. Subsequently, an alternative technique is applied, where specimens are prestrained and then allowed to relax. In the following dynamic mechanical analysis, viscoelastic effects can be avoided. Considerations on the onset and evolution of damage are made. Ultimately, these results are confirmed through microcomputed tomography, where the shapes and densities of defects are captured in high resolution.
KW - computed tomography
KW - damage
KW - elastic modulus decay
KW - polypropylene
UR - http://www.scopus.com/inward/record.url?scp=85127451301&partnerID=8YFLogxK
U2 - 10.1002/pen.25979
DO - 10.1002/pen.25979
M3 - Article
AN - SCOPUS:85127451301
SN - 0032-3888
VL - 62.2022
SP - 1959
EP - 1973
JO - Polymer Engineering and Science
JF - Polymer Engineering and Science
IS - 6
ER -