Comparison of hydraulic and fully electrical injection moulding machines for PIM

C. Kukla, J. Ter Maat

Publikation: Beitrag in Buch/Bericht/KonferenzbandBeitrag in Konferenzband

Abstract

In the last decade fully electrical injection moulding machines are more and more used in the injection moulding market. On the difference between hydraulical and fully electrical machines some publications are available and also many investigations were carried out. But all of this work has been done for thermoplastics. Therefore an investigation was done to compare the behaviour of hydraulic and fully electrical injection moulding machines for PIM feedstocks. A special mould was designed with a thin-walled and a thick-walled cavity. With this mould parts were produced and the process parameters taken. Thus the machine behaviour and the reproducibility can be examined. Here the results of this investigation are shown together with a more detailed comparison of the hydraulic and the fully electrical injection moulding machine concepts.

OriginalspracheEnglisch
TitelPowder Injection Moulding
Herausgeber (Verlag)European Powder Metallurgy Association (EPMA)
Seiten37-42
Seitenumfang6
ISBN (elektronisch)9780000000002
PublikationsstatusVeröffentlicht - 1 Jan. 2006
Extern publiziertJa
VeranstaltungEuropean Powder Metallurgy Congress and Exhibition, Euro PM 2006 - Ghent, Belgien
Dauer: 23 Okt. 200625 Okt. 2006

Publikationsreihe

NameEuro PM 2006 - Powder Metallurgy Congress and Exhibition
Band2

Konferenz

KonferenzEuropean Powder Metallurgy Congress and Exhibition, Euro PM 2006
Land/GebietBelgien
OrtGhent
Zeitraum23/10/0625/10/06

Dieses zitieren