Heat Treatments and Critical Quenching Rates in Additively Manufactured Al–Si–Mg Alloys

Leonhard Hitzler, Stephan Hafenstein, Francisca Mendez Martin, Helmut Clemens, Enes Sert, Andreas Öchsner, Markus Merkel, Ewald Werner

Publikation: Beitrag in FachzeitschriftArtikelForschungBegutachtung

8 Zitate (Scopus)

Abstract

Laser powder-bed fusion (LPBF) has significantly gained in importance and has become one of the major fabrication techniques within metal additive manufacturing. The fast cooling rates achieved in LPBF due to a relatively small melt pool on a much larger component or substrate, acting as heat sink, result in fine-grained microstructures and high oversaturation of alloying elements in the ff-aluminum. Al-Si-Mg alloys thus can be effectively precipitation hardened. Moreover, the solidified material undergoes an intrinsic heat treatment, whilst the layers above are irradiated and the elevated temperature in the built chamber starts the clustering process of alloying elements directly after a scan track is fabricated. These silicon-magnesium clusters were observed with atom probe tomography in as-built samples. Similar beneficial clustering behavior at higher temperatures is known from the direct-aging approach in cast samples, whereby the artificial aging is performed immediately after solution annealing and quenching. Transferring this approach to LPBF samples as a possible post-heat treatment revealed that even after direct aging, the outstanding hardness of the as-built condition could, at best, be met, but for most instances it was significantly lower. Our investigations showed that LPBF Al-Si-Mg exhibited a high dependency on the quenching rate, which is significantly more pronounced than in cast reference samples, requiring two to three times higher quenching rate after solution annealing to yield similar hardness results. This suggests that due to the finer microstructure and the shorter diffusion path in Al-Si-Mg fabricated by LPBF, it is more challenging to achieve a metastable oversaturation necessary for precipitation hardening. This may be especially problematic in larger components.

OriginalspracheEnglisch
Aufsatznummer720
Seitenumfang17
FachzeitschriftMaterials
Jahrgang13.2020
Ausgabenummer3
DOIs
PublikationsstatusElektronische Veröffentlichung vor Drucklegung. - 5 Feb. 2020

Bibliographische Notiz

Publisher Copyright:
© 2020 by the authors.

Dieses zitieren