Injection Molding Simulation of Polyoxymethylene Using Crystallization Kinetics Data and Comparison with the Experimental Process

Theresia Schrank, Michael Berer, Bernd Haar, Bruno Ramoa, Thomas Lucyshyn, Michael Feuchter, Gerald Pinter, Vito Speranza, Roberto Pantani

Publikation: Beitrag in FachzeitschriftArtikelForschungBegutachtung

Abstract

It is well known that the processing conditions in polymer processing have a high impact on the resulting material morphology and consequently the component’s mechanical behavior. However, especially for semicrystalline polymers, the tools available for predicting the final morphology of injection molding parts still have significant limitations. In order to investigate the potential of injection molding simulation for the prediction of the morphology, POM homopolymer specimens were injection molded. The crystallization kinetics data were measured, and simulations in 3D and 2.5D with and without crystallization analysis were conducted in Autodesk Moldflow. The simulations are found to be good accordance with the experiments. Predicted spherulite size and crystalline orientation factor reveal a good qualitative correlation with optical micrographs. Also, the evolution of these parameters along the flow path is plausible. The simulation is found to be a powerful tool for morphology prediction in polymeric parts. Its applicability, however, is still limited to 2.5D models in Autodesk Moldflow, which, of course, is insufficient for complex, thick-walled 3-dimensional parts.
OriginalspracheEnglisch
Seitenumfang15
Fachzeitschrift Polymer crystallization
Jahrgang2022
DOIs
PublikationsstatusVeröffentlicht - 23 März 2022

Dieses zitieren