Description
The aim of this study is to investigate the influence of friction coefficient and to a lesser the influence of initial winding angle on the winding angle development along a conical surface. Then to obtain the feasible design space for wet and dry winding and generate different winding trajectories on the conical mandrel surface. The equations for winding angle and coordinates of the fiber trajectory have been developed for a truncated cone using differential geometry. The influence of initial winding angle and friction coefficient on the distribution of winding angles along the height of the cone has been investigated. The feasible design space has been obtained for two different friction coefficients corresponding to wet and dry winding. Winding trajectories namely geodesic, non-geodesic and constant winding angle has been generated on the truncated cone. The results show that friction coefficient has a huge effect on the winding angle development and can significantly enlarge the design flexibility. It can be used to manipulate the fiber trajectories without causing slippage. A combined path can be achieved from a non-geodesic and a constant winding angle path to achieve a specific fiber direction. The combined path meets the necessary requirements in filament winding process and can be used to enhance the structural performance of the truncated cone by placing the fibers along the principal stress directions.Period | 24 Jun 2018 → 28 Jun 2018 |
---|---|
Event type | Conference |
Location | Athen, GreeceShow on map |
Degree of Recognition | International |
Keywords
- Winding Angle
- Friction Coefficient
- Design Space
- Geodesic
- Non-geodesic
Related content
-
Publications and Theses
-
Winding Trajectories for Dry Filament Wound Preforms
Research output: Contribution to conference › Paper
-
Inline control of tape width during automated tape placement
Research output: Chapter in Book/Report/Conference proceeding › Conference contribution