Micromechanical Properties of Micro- and Nanocrystalline CVD Diamond Thin Films with Gradient Microstructures and Stresses

Michael Meindlhumer, Tobias Ziegelwanger, Jakob Grau, Hadwig Sternschulte, Michael Sztucki, Doris Steinmüller-Nethl, Jozef Keckes

Research output: Contribution to journalArticleResearchpeer-review

Abstract

Chemical vapor deposition produced diamonds attract considerable scientific and industrial interest due to their exceptional mechanical and functional properties. Here, hot filament (HF) chemical vapor deposition was used to synthesize two diamond thin films with different cross-sectional microstructure and residual stresses. Structural characterization by scanning electron microscopy, Raman spectroscopy, and cross-sectional synchrotron x-ray nanodiffraction revealed different diamond morphologies. While the microcrystalline diamond film exhibits pronounced microstructural gradients expressed by gradually increasing (i) intensities of the 111 Debye-Scherrer rings, (ii) fiber texture sharpness, (iii) grain size, and (iv) slightly oscillating residual stress at the level of −0.5 GPa, the nanocrystalline diamond film showed no pronounced cross-sectional variation of microstructure above the nucleation zone of ∼0.5 μm and a steady stress level of 0.25 GPa. In situ micromechanical cantilever bending tests revealed highly different mechanical properties of the two films. In detail, Young's modulus of 830 ± 53 and 459 ± 53 GPa, fracture stress of 12.4 ± 0.8 and 7.8 ± 1.0 GPa, and fracture toughness values of 6.9 ± 0.4 and 3.6 ± 0.3 MPa⋅m½ were evaluated for the micro- and nanocrystalline diamond films, respectively. In summary, this study provides valuable insights into the microstructure-residual stress correlation in micro- and nanocrystalline diamond films, especially illuminating their influence on micromechanical properties.
Original languageEnglish
Article number023401
Number of pages12
JournalJournal of Vacuum Science and Technology A: Vacuum, Surfaces and Films
Volume42.2024
Issue number2
DOIs
Publication statusPublished - 12 Jan 2024

Cite this