Materials science and engineering: A, Structural materials: properties, microstructure and processing, 0921-5093

Fachzeitschrift: Zeitschrift

ISSNs0921-5093
Weitere suchbare ISSN (eISSN)1873-4936

Publikationen

  1. 2008
  2. Veröffentlicht

    Influence of grain size on orientation changes during plastic deformation

    Scheriau, S. & Pippan, R., 2008, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 493, S. 48-52

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  3. Veröffentlicht

    On the overaging behaviour of tool steel X38CrMoV5-3

    Bischof, M., Staron, P., Caliskanoglu, Z. D., Leitner, H., Scheu, C. & Clemens, H., 2008, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 472, S. 148-152

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  4. Veröffentlicht

    Precipitation processes in a Mg–Zn–Sn alloy studied by TEM and SAXS

    Rashkova, B., Prantl, W., Görgl, R., Keckes, J., Cohen, S., Bamberger, M. & Dehm, G., 2008, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. A494, S. 158-164

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  5. 2007
  6. Veröffentlicht

    Analysis of roughness-induced crack closure based on asymmetric crack-wake plasticity and size ratio effect

    Pippan, R. & Pokluda, J., 2007, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. A462, S. 355-358

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  7. Veröffentlicht

    Changes in the mechanical properties of a pearlitic steel due to large shear deformation

    Wetscher, F., Stock, R. & Pippan, R., 2007, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 445-446, S. 237-243

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  8. Veröffentlicht

    FIB damage of Cu and possible consequences for miniaturized mechanical tests

    Kiener, D., Motz, C., Rester, M., Jenko, M. & Dehm, G., 2007, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 459, S. 262-272

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  9. 2006
  10. Veröffentlicht

    Annealing studies of nanocomposite Ti-Si-C thin films with respect to phase stability and tribological performance

    Rester, M., Neidhardt, J., Eklund, P., Emmerlich, J., Ljungcrantz, H., Hultman, L. & Mitterer, C., 2006, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 429, S. 90-95

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  11. Veröffentlicht

    Characterisation of Residual Stresses in Turbine Discs by Neutron and High-Energy X-Ray Diffraction and Comparisation to Finite Element Modeling

    Cihak, U., Staron, P., Clemens, H., Homeyer, J., Stockinger, M. & Tockner, J., 2006, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 437, S. 75-82

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  12. Veröffentlicht

    Comparison of NiAl precipitation in a medium carbon secondary hardening steel and C-free PH13-8 maraging steel

    Erlach, S. D., Leitner, H., Bischof, M., Clemens, H., Danoix, F., Lemarchand, D. & Siller, I., 2006, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 429, S. 96-106

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  13. Veröffentlicht

    Dynamic recrystallization of NI-base alloys-Experimental results and comparisons with simulations

    Poelt, P., Sommitsch, C., Mitsche, S. & Walter, M., 2006, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. S. 306-314

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  14. Veröffentlicht

    Evolution of misorientation distribution during warm 'abc' forging of commercial-purity titanium

    Mironov, S. Y., Salishchev, G. A., Myshlyaev, M. M. & Pippan, R., 2006, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 418, S. 257-267

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  15. Veröffentlicht

    Microstructural evolution of Cr-Mn-N Austenitic Steels during Cold Work Hardening

    Saller, G., Spiradek-Hahn, K., Scheu, C. & Clemens, H., 2006, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 427, S. 246-254

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  16. Veröffentlicht

    On the texture of spray formed gamma titanium aluminide

    Staron, P., Bartels, A., Brokmeier, H-G., Gerling, R., Schimansky, F-P. & Clemens, H., 2006, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 416, S. 11-17

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  17. Veröffentlicht

    Shape Factors in Modeling of Precipitation

    Kozeschnik, E., Svoboda, J. & Fischer, F. D., 2006, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 441, S. 68-72

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  18. Veröffentlicht

    The High-temperature Background in Intermetallic Alloys

    Weller, M., Clemens, H. & Haneczok, G., 2006, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 442, S. 138-141

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  19. 2005
  20. Veröffentlicht

    Modeling the columnar-to-equiaxed transition with a three-phase Eulerian approach

    Ludwig, A. & Wu, M., 15 Dez 2005, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 413-414, S. 109-114 6 S.

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  21. Veröffentlicht
  22. Veröffentlicht

    Analysis of the Precipitation Behaviour in a High Speed Steel with Small Angle Neutron Scattering

    Leitner, H., Staron, P., Clemens, H., Marsoner, S. & Warbichler, P., 2005, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 398, S. 323-331

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  23. Veröffentlicht

    Discrete dislocation simulation of nanoindentation: The effect of statistically distributed dislocations

    Kreuzer, H. G. M. & Pippan, R., 2005, in : Materials science and engineering: A, Structural materials: properties, microstructure and processing. 400-401, S. 460-462

    Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

  24. Veröffentlicht